IWILL KK400 Series, Руководство пользователя

Страница: 66 / 110

KK400 Series Motherboar KK400 Series Motherboar
KK400 Series Motherboar KK400 Series Motherboar
KK400 Series Motherboard d
d d
d
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
U U
U U User’
ser’
ser’ ser’ ser’s Manual
s Manual
s Manual s Manual s Manual 5•4 5•4 5•4 5•4 5•4
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
IDE Drive Positioning
Normally the system’s primary hard disk drive should be
in the Primary Master position. If you will use only the
supplied ribbon cable, connect a CD-ROM drive to the
Primary Slave position.
If you obtain an additional IDE ribbon cable, you can
install a second hard disk drive in the Primary Slave posi-
tion and install the CD-ROM as the Secondary Master.
This is a good idea if the CD-ROM drive uses a slower
data transfer mode than the hard disk drive.
Follow any instructions that come with the drives to con-
figure and install them. IDE devices generally can be set
to one of three operation modes:
• Master
• Slave
• Cable Select
Many drives come set to the Master setting. If you will
use the drive in a Slave position, you must reconfigure it
as either Slave or use the Cable Select setting to allow the
drives position on the cable to define the mode.
Connecting a Floppy Disk Drive
This motherboard has one Floppy Drive connector for
connecting one or two floppy disk drives. Most computer
systems use one 3.5-inch 1.44MB floppy disk drive. The
drive connector is for a standard floppy drive ribbon cable.
To install a floppy disk drive, connect the drive to the end
of the cable, which is the Drive A: position. Plug the other
end of the cable into the floppy disk drive connector on
the motherboard.
Connecting a Smartcard or MS/SD Reader
This motherboard has connectors for a Smartcard reader
(JP13) and a Memory Stick™ or Secure Digital™ memory
card reader (J29). You can either connect individual mod-
ules to them or you can connect the appropriate cables
from the optional FI Panel.
To connect any of these devices, follow the instructions
that come with them. You will need to connect a module
cable to the appropriate connector and enable the feature
in the “Integrated Peripherals” section of the CMOS Setup
Utility. The default port settings listed should work.
Cable Select: Cable Select:
Cable Select: Cable Select:
Cable Select:
Not all drives work prop-
erly with Cable Select
mode. If you try to use
this mode and the drive
does not operate prop-
erly, set the drive to ei-
ther Master or Slave
mode, as appropriate for
its position on the cable.