iWeld FANTOM 4.6, Руководство пользователя

Страница: 36 / 46

EN
4. Shade Control / Sensitivity Control / Grinding Control
4.1. Welding/Grinding switch is in -
side on the LCD cartridge
Each model allows a choice of two user
modes:
welding and grinding (Grind).
Grinding the dark mode function is off.
During this time the LCD is the brightest
state, helping to get a clearer view next
to a maximum protection.
When grinding, the helmet shell can not bear the welding spatter which is more than
43 grams and exceeding 120m/sec. The helmet meet standard DIN EN 175:1997
(B impact Level). For other body parts helmet can not protect, please wear other
safety products for protection!
Before welding, please adjust the sensitivity
to high position, if encountering the interfer -
ence of Lighting lamp(the filter is darkening
while not welding),please adjust the sensitiv -
ity towards low position slightly until the filter
returns to light state (please don’t make the
helmet towards to light lamp source during
this process, should towards to welding wor -
piece). During welding, the sensitivity knob
should be adjusted as high as possible, or it
will affect the darkening speed of filter.
Attention! Operator must stop using the helmet immediately and contact with the
dealer in time if the filter can not be darkening or the darkening speed is slow or the
filter is flash!
4.2. Sensitivity knob
LO
HI
5 4