iWeld FANTOM 4.6, Руководство пользователя

Страница: 34 / 46

EN
1. Before welding
The FANTOM 4.6 Welding Helmet comes ready for use. The only thing you need to do
before your welding is to adjust the position of the headband and select the correct
shade number for your application.
Check the front cover lens to make sure that they are clean, and that no dirt is cover -
ing the four sensors on the front of filter cartridge. Also check the front/ inside cover
lens and the front lens retaining frame to make sure that they are secure.
Inspect all operating parts before use for signs of wear or damage. Any scratched
cracked, or pitted parts should be replaced immediately before using again to avoid
severe personal injury.
Check for light tightness before each use.
Select the shade number you require at the turn of a shade knob ( Seeing the Shade
Guide Table No.1 ). Finally, be sure that the shade number is the correct setting for
your application.
Adjust headband so that the helmet is seated as low as possible on the head and
close to your face. Adjust helmet’s angle when in the lowered position by turning the
adjust- able limitation washer.
2. Dark shade number selection
The shade number can be set manually between 9-13 . Check the Shade Guide
Table to determine the proper shade number for your application. Select a shade
number by turning the shade knob until the arrow points to the required setting (See
Shade Guide Table No.1).
Arc Gouging
MIG Sheet Metal
MIG Plate welding
3 2