Iwatsu SS-560, Инструкция по эксплуатации, Страница: 8 / 36

4
Read this page to ensure proper safety. (to be continued)
WARNING
•
Be careful not to damage the insulated sheath of the
insulated target conductor to be measured.
•
Make sure the oscilloscope connected to the BNC output
connector on the current probe is used with the protective
earth.
See "Recommended Power Supply and Oscilloscope" of the
appendix in the end of this manual for the instrument of our
company that corresponds to this.
•
Connect only the recommended power unit to this
instrument.
Use of power units not suited may result in fire or equipment
damage. See "Recommended Power Supply and Oscilloscope" of
the appendix in the end of this manual for the recommended power
supply of our company.
•
When handling power cables and sensor cables:
This may result in fire, electric shock or equipment damage. If the
power cord is damaged, contact IWATSU or our sales distributors for
repair.
⋅
Do not attempt to fabricate power cord and sensor cable.
⋅
Do not pull power cord and sensor cable by the cable. Always
grasp the plug.
⋅
Do not bend power cord and sensor cable.
⋅
Do not heat power cord and sensor cable.
⋅
Do not twist power cord and sensor cable.
⋅
Avoid getting power cord and sensor cable wet.
⋅
Do not bind power cord and sensor cable together.
⋅
Do not place heavy objects on top of power cord and sensor
cable.
•
Do not place this instrument in an area there frequent
vibrations or impacts occur.
If this instrument is dropped or overtuned, it may cause a physical
injury or a malfunction.