Iwatsu ADIX VS, Техническое руководство

Страница: 101 / 136

Chapter 6 – Optional Feature Installation
91
Play BGM Through Individual Paging Zones
Follow the steps below to route BGM, using the VS-MISC interface, to up to two external zone
outputs. You can enable or disable BGM for each zone by setting strapping jacks for ZONE1 through
ZONE2 on the VS-MISC card.
)
Setup and Programming
1. Access the programming mode from a programming KT,or PC Programmer. Go to Class 04
Item 03-BGM Input Port. Set the BGM input to be equal to the second miscellaneous port on
the VS-MISC card-002 and press[ENTER].
2. Go to Class 04 Item 04-BGM output Port. Enter either the miscellaneous logical port number
of the BGM source(second circuit on the VS-MISC),or the miscellaneous logical port
number of Page Zone 1(first circuit on the VS-MISC). Either of these data entries will cause
BGM output through the page circuit(pin 3 and 4, TA IN, on the punchdown block).
3. Make sure the BGM AMP strapping jack on the VS-MISC card is in the RIGHT position.
This will cause BGM to output pins 7 and 8 BGM OUT on the punchdown block.
4. Connect the BGM extarnal amplifier input to pins 7 and 8 BGM OUT on the punchdown
block as illustrated in Figure 42.
5. Connect the speaker output of the external amplifier to pins 17 and 18 ZONE BGM IN on the
punchdown block as illstrated in Figure 42. Connect the output from the punchdown block to
one quick-connection type connector on the VS-MISC card.
6. Reset the system to effect the programming changes.
24
23
22
21
20
19
18
17
16
15
14
13
8
7
6
5
4
3
2
1
BGM
Source
BGM
Amplifier
PAGE
Amplifier
Relay
- +
Input Output
Control
Zone 1
Zone 2
Output Input
Output
FIGURE 42. BGM THROUGH INDIVIDUAL PAGING ZONES