5
Ignition, adjusting the heating power, and extinguishing the flame
Ignition
Adjusting the heating power
Extinguishing
ON
OFF
ON
OFF
High
Low
Turn the ON/OFF knob
in the “ON” direction
until it clicks. Make sure
the flame was lit.
ON
OFF
ON
OFF
High
Low
Turning the ON/OFF
knob in the “ON”
direction increases the
heating power, while
turning in the “OFF”
direction decreases it.
ON
OFF
ON
OFF
High
Low
Turn the ON/OFF
knob in the “OFF”
direction until it
stops.
● If there is no flame, return the ON/OFF knob
to the “OFF” position, and then try again.
It may be difficult to light the product upon
first use or when the temperature of the
canister is low. With caution, repeat the
ignition operation several times.
● When using low heat, always check the flame
as it is difficult to see.
● Be aware that if the flame is lowered too much,
it is more likely to be extinguished by wind.
After use (steps after extinguishing the flame)
Make sure the flame is out completely
● Just after the flame is extinguished, both the
main unit and the canister will be hot.
Wait until they cool down.
Remove the canister
● Always remove the canister.
Otherwise, appliance failures or gas
leaks may occur.
Ignite a flame after the canister has been
removed
● A small amount of gas remains in the piping
of the main unit. To prevent danger, perform
ignition one time to burn off the remaining gas.
● If the unit is exposed to rain or snow you may have trouble lighting the burner until the burner ports are clear of water
and the spark electrode is totally dry. To protect against burner ignition problems due to water accumulation, the
storage box also serves as a rain guard when the stove is left outdoors and exposed to the elements.
Never leave the stove outside without first storing it in the storage box provided. Remove butane canister before
storage.
Removing the canister after use
After use, always remove the canister, put on the canister cap,
and then store the canister.
Open the canister cover. While holding the canister, apply a small amount
of force in the direction opposite the installation direction to remove it
from the magnet.
Put the canister cap on the removed canister.
Close the canister cover.
