4
Disassembling and assembling the double windshield unit
Wait until the stove has cooled before
disassembling the double windshield unit.
If the double windshield unit is stained, you can disassemble and clean it. (Maintenance method → Page 9)
After cleaning, reverse the disassembly procedure to assemble the double windshield unit, install it on the main unit, and then store the
stove in a location with low humidity.
[Disassembly method]
With your fingers, strongly pinch a grate clip in one
of the four corners on the back side of the double
windshield unit.
While pinching it, pull out the clip horizontally.
[Assembly method]
Attach the inner windshield unit to the
outer windshield unit.
Secure the units using the 4 grate clips.
[Attachment method]
Attach the double windshield
unit so that it fits with this
surface of the windshield unit
holder.
● When all 4 grate clips have been removed, the inner
and outer windshield units can be disassembled.
● The grate clips are designed exclusively for the stove,
so take care not to lose them.
Inner windshield unit
Outer windshield unit
Insert
Double
windshield unit
<Back side of
double windshield unit>
Grate clip
Preparations (About the carrying case)
Remove the stove from the carrying case.
● Place the carrying case in a location in which is not affected by heat. (Wait until the stove has cooled before storing it.)
Never use the stove while it is inside the carrying case, because the carrying case will deform or melt.
Installing canister
Install a canister following the procedure below.
Be aware that if a canister is installed incorrectly, unexpected dangers may result.
Open the canister cover.
Turn the ON/OFF knob in the “OFF” direction until
it stops.
● If the ON/OFF knob is not in the “OFF” position, the
canister installation safety device is activated, and
the canister cannot be installed.
Make sure no foreign objects have adhered to the
magnet.
Remove the canister cap of the canister.
OFF
ON
When foreign objects have adhered to the
magnet
If iron scraps or powder have stuck to the
magnet, a gas leak may occur or it may not be
possible to install the canister. If foreign objects
have stuck to the magnet, use adhesive tape to
remove them.
Iron powder and scraps
Adhesive tape
When it is difficult to install the
canister (because force is required),
apply a thin coat of vegetable oil to
the tip of the canister (Part
in the
illustration below).
Application location for
vegetable oil
Place the canister on the heat panel and align the
canister notch with the protrusion of container-
receiving guide.
As shown in the illustration to the right, place
your hand near the top of the canister, slide
the canister horizontally, and push it until it fits
completely with the magnet.
Protrusion of
container-
receiving
guide
Canister notch
When using “Iwatani Butane Fuel”
When the canister has been installed
correctly, there is a gap of about 0.8"/2 cm
at the back end of the canister.
The canister installation section is
designed to move with some “play”.
This gap does not indicate a problem,
so please use this product with peace
of mind.
Install the canister securely so that there is no gap
between the magnet and canister.
After the canister has been installed, close the
canister cover.
Always use a fuel canister labeled as “Iwatani Butane Fuel” or “FORE WINDS Butane Fuel”
