7
removing the insulating strip from the remote control
Remove the insulating mylar strip from the
battery if the battery is being used for the first
time. It is located at the bottom back side of the remote
control.
battery installation for the remote control
1. Press and hold the battery release tab and pull
out the battery holder completely.
handling the battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which
could cause fire, personal injury or damage to property.
• Install the battery correctly by following the polarity (+ and –) indications in the battery
compartment.
• When the battery is exhausted, the remote control will not function.
• Only use the battery type indicated in this manual.
• Do not dispose of the used battery as domestic waste. Dispose of it in accordance with
the local regulations.
• Small button cell batteries such as the one used in the remote control are easily
swallowed by young children and this is dangerous. Keep loose button cells away from
young children and make sure that the battery holder tray is secure in the remote
control. Seek medical advice if you believe a cell has been swallowed.
• If you are not going to use the unit for a long time, remove the batteries to avoid damage
from battery leakage and corrosion.
handling the remote control
• Take care of your fingernails when you press and hold the battery release tab.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the battery from the remote control when not in use for a long period of time,
as it could cause corrosion or battery leakage and may result in physical injury and/or
property damage including fire.
2. Remove the old battery, and place a new
battery (“CR2025” 3V) in the holder.
iPHWAV10_IB_final110509.indd 7
09/05/2011 4:45 PM
