IVT CSD-12, Инструкция по эксплуатации

Страница: 12 / 84

12
Manual instruction
EN
drills.
By turning the knob on your Drill/Screwdriver, you
can set the necessary step from 1 (easily – turned
screws) to 16 (hard – to – turn screw or drilling).
Always select the appropriate torque for the work in
hand at the time.
fig.2
Switching On/Off
Switching on:
Press on/off switch (4)
Switching off:
Release on/off switch (4)
fig.3
Stepless speed control
The machine runs with variable speed
between 0 and maximum depending on
the pressure applied to the on/off switch
(4).
Speed selection
(CSD-16.8G; CSD-18G)
With the thumbwheel (8) the required speed can be
selected (also while running).
The required speed is dependent on the material
and can be determined with practical trials. After
longer periods of working at low speed, allow the
machine to cool by running for approx. 3 minutes at
maximum speed with no load.
fig.4
Changing the rotational directions
Operate the rotational direction switch (3) only at
a standstill.
With the rotational direction switch (3), the rotational
direction of the machine can be switched (when the
on/off switch (4) is operated, the rotational direction
switch (3) is locked).
Right Rotation
Press the rotational direction switch (3) through to
the right stop (for drilling, driving screws, etc.).
Left Rotation
Press the rotational direction switch (3) through to
the left stop (for loosening and unscrewing screws
and nuts).
fig.5