17
Alarm Output:
There is a active warner connected to the alarm output port. Once alarm triggers that it will
linkage embedded relay switch to make alarm output
Enable PTZ:
When motion detection triggers alarm, it will linkage the PTZ motion
Preset:
When motion detection triggers alarm, it will linkage the presets
Snap Interval:
Set the snapshot interval time
Snap Count:
Set the snapshot image count for this time
After complete all parameters setting, click
Save
and then the settings will take effect immediately.
4.14 Network Settings
IP Camera
Network Settings
interface as shown in the follow figure:
IPV4:
IP protocol version No. is 4
IPV6:
IP protocol version No. is 6, the feature is not optional at present
Static IP:
The device IP address is permanent
DHCP: Enable
DHCP, then IP camera will get the IP address from router automatically
IP Address:
Input the corresponding numbers to change the IP address
Subnet Mask:
Input the corresponding IP subnet mask
Gateway:
Input the corresponding gateway address
DNS 1:
DNS server IP address
DNS2:
DNS server second IP address
HTTP Port:
Input the corresponding port ( Default is 80)
HTTPS Port:
Input the corresponding port ( Default is 443)
RTSP Port:
Use domain name to access and login device need mapping RTSP, default port is 554
RTMP Port:
Use domain name to access and login device need mapping RTMP, default port is 1935
Enable UPnp:
Enable UPnp, then device port and HTTP port will be mapped to the router automatically
Device Port:
Input the corresponding device port(Default is 5050)
Enable PPPoe:
Click to enable PPPOE
User Name:
Input the user name
Password:
Input the password
Confirm pwd:
Input the password again to confirm it
PPPoe IP:
Input device dynamic address
After complete all parameters setting, click
Save,
then the settings will take effect immediately.
Содержание NC649A
Страница 1: ...Network Camera User Manual...
