There are eight submenus under the Wireless 2.4G menu:
Basic, Security, Access, WDS, WPS, Schedule.
Click any of
them, and you will be able to configure the corresponding function.
This page is used to configure the parameters for wireless LAN clients which may connect to your Access Point. Here you
may change wireless encryption settings as well as wireless network parameters.
This page allows you setup the wireless security. Turn on WEP or WPA by using Encryption Keys could prevent any
unauthorized access to your wireless network.
Disable Wireless LAN Interface:
Check this box to to disable the router’s wireless features; uncheck to enable it.
Band:
Select one mode from the following. The default is 2.4GHz (B+G+N) mode.
Mode:
Support AP, Client, WDS and AP+WDS mode.
SSID:
SSID (Service Set Identifier) is the unique name of the wireless network.
Channel Width:
Select the channel width from the drop-down list.
Control Sideband:
This relates to the channel number used for your wireless network. An upper band represents higher
channels and vice versa.
Channel Number:
Indicates the channel setting for the router.
Broadcast SSID:
Select “Enable” to enable the device's SSID to be visible by wireless clients. The default is enabled.
WMM:
It will enhance the data transfer performance of multimedia data when they’re being transferred over wireless
network.
Data Rate:
Sets the maximum wireless data rate that your network will operate on.
Associated Clients:
You can see the MAC Address, MAC address, transmission and reception packet counters for each
associated wireless client.
3.4 Wireless Setup
Status
Internet Setting
Wireless Setup
Basic
Security
Access
WDS
WPS
Schedule
Firewall
Security
QoS
System
Advanced
Logout
Wireless Basic Setting
This page can be congured to connect to a wireless client parameter access point, you can set the basic parameters of the
wireless network.
Disable Wireless LAN Interface
Band :
Mode :
Network Type :
SSID :
Channel Width :
Control Sideband :
Channel Number :
Broadcast SSID :
WMM :
Data Rate :
Associated Client
Enable Mac Clone (Single Ethernet Client)
Enable Universal Repeater Mode (Acting as AP and
client simultaneously)
2.4 Ghz (B+G+N)
AP
Infrastructure
40MHz
Upper
11
Enable
Auto
Show Active Clients
Enable
iVOOMi_Speed600
3.4.1 Basic
3.4.2 Security
18
