1.1.
Mark the edge of
your door at the
desired height
of your lever.
1.2.
We recommend
around 900mm –
1100mm from fl oor
level, or at the
centre of a lock rail
on a panel door.
(Figure 1)
1. Marking
the Door
Preferred product
height
Figure 1.
2. Install Latch, Privacy Bolt & Striker Plates
As per supplier instructions, resources available
at iver.com.au/resources.
Figure 2.
1.3.
Using a spirit level,
mark the door at the
desired lever height,
continuing the line
from the front of
the door, around the
edge and onto the
back of the door.
(Figure 2)
1.4.
We recommend
extending the line
100mm onto each
face of the door.
3.1.
If required, shorten tie bolts to suit door thickness.
(Figure 3)
3. Prepare Tie Bolts
— if using face fi x timber screws, proceed to step 4
3.2.
Ensure to cut so that the screw does not protrude
from the opposite plate once installed. (Figure 4)
Figure 4.
Figure 3.
(8)
4.1.
Slide spring over snib neck and place neck
through hole in internal backplate. (Figure 5)
4. Install Privacy Adaptor Snib Release
Figure 5.
(1)
(5)
(2)
(4)
4.2.
Affi
x circlip to groove in snib neck on inside
of backplate. (Figure 6)
4.3.
Repeat for emergency release on external-facing
backplate.
Figure 6.
(2)
(5)
(4)
