Pressure transducer installation
precautions
Before installation of the pressure transducer the hydraulic
lift circuit make sure to be pressure free.
Make sure that that installed pressure transducer will not
touch any moving parts or assembly of the vehicle while in
normal operation. Pressure transducer has
1/4”-18 NPT
male thread
. Use thread seal to ensure tight fit.
Selecting the mounting location
for digital indicator
Use the mounting bracket with the anti vibration mount and
fasten digital indicator on the vehicle dashboard, load
backrest or any other convenient place on the electric pallet
truck dashboard body There are many examples of
mounting locations that will depend on the vehicle model.
However, additional mounting items such as a flat brackets
may be needed to help secure the unit.
Electrical Connections
All SkidWeigh systems operate from 12 to 55 VDC.
Orange Wire
(+) Vehicle power on / Ignition switch On position
Brown Wire
(-) Battery negative
Red Wire,
connect to RED wire of the pressure transducer cable
Black Wire,
connect to BLACK wire of the pressure transducer cable
White Wire,
connect to WHITE wire of the pressure transducer cable
NOTE:
Two
BLACK wires
are connected to the internal relay, dry contacts NC contact located in the ED2-EP
digital indicator. The internal relay is controlled by the microprocessor and will be activate only during the
load weighing cycle.
There is no power connected to these two BLACK wires.
Integrated Visual Data Technology Inc. 3439 Whilabout Terrace, Oakville, Ontario, Canada L6L 0A7
