28
6.4. - Sensor calibration
Deviations in the temperature values displayed, for example due to cables which are to
long or sensors which are not positioned optimally, can be compensated for manually
here. The settings can be made for each individual sensor in steps of 0.5°C.
6.5. - Commissioning
Starting the commissioning help guides you in the correct order through the basic set-
tings necessary for commissioning, and provides brief descriptions of each parameter
in the display. Pressing the “esc” key takes you back to the previous value so you can
look at the selected setting again or adjust it if desired. Pressing the “esc” more than
once takes you back to the selection mode, thus cancelling the commissioning help.
(see also 5.1)
6.6. - Factory settings
All of the settings that have been made can be reset, thus returning the controller to its
delivery state.
Special functions
6.7. - Time & Date
This menu is used to set the current time and date.
Caution
Settings are only necessary in special cases at the time of initial commissioning
by the specialist. Incorrect measurement values can lead to unpredictable errors.
Caution
May only be started by a specialist during commissioning! Observe the ex-
planations for the the individual parameters in these instructions, and check
whether further settings are necessary for your application.
Caution
The entire parametrisation, analyses, etc. of the controller will be lost irrevocably.
The controller must then be commissioned once again.
For proper functioning of the controller and statistics for the system data it is
essential for the time to be set accurately on the controller. Please note that
the clock continues to run for about 24 hours if the mains voltage is interrupted,
and after that has to be reset.
Caution
