ITW Trans Tech Aero 60, Руководство оператора

Страница: 12 / 43

Aero 60/90
Printer Operation
1.3
Release 2.0 PAGE 12
1.3.3 Removal of the Cliché and Ink Cup
When removing the ink cup from the machine, proceed as described in the following instruction:
1. Stop the AERO printer via the ‘STOP’ button in the ‘HOME’ position (Pad forward and
up).
2. Open the machine guard and remove pad
3. Place MAGNETIC CUP CLAMPS on the front and rear of the CUP
4. Loosen the cliché clamping screws and move the cliché clamp to clear the cliché
5. Using the T handle ALLEN wrench, turn the machine clamping screw clockwise to lift
the clamping fingers clear of the ‘HOLD DOWN RING’ (3)
If the machine has been assembled for an extended period of time, accumulation
of ink may inhibit the removal of the cliché’. This may cause the ink cup to pull
free from the cliché’ and to spill the ink. Verify that the cliché’ and ink cup slide
out together!
6.
Draw the cup/cliché assembly out of the machine and turn it over with the ink cup
facing down
7.
Set assembly into the ‘SETUP TABLE’ (1) and tighten the thumb screws
8.
Slide the cliché off the ink cup. The ink remaining on the cliché will be stripped off
If the printing machine will not be in operation for an extended time, the ink can
remain in the cup without deterioration of the ink.