ITW Trans Tech Aero 60, Руководство оператора

Страница: 11 / 43

Aero 60/90
Printer Operation
1.3
Release 2.0 PAGE 11
1.3.2. Installation of the Cliché and Ink Cup
Illustration 2-2. Ink cup assembled on assembly table
When preparing the ink cup to be placed into the machine for printing, proceed as described in the
following instruction:
1. Insert both ‘MAGNETIC CUP CLAMPS’ (4) with the top down into the ‘SETUP TABLE’ (1) Tighten thumb
screws snuggly to retain clamps.
2. Place the ExpressLiner (2) with the opening up into the SpaceFrame (3)
3. Place SpaceFrame assembly into ‘MAGNETIC CUP CLAMPS’ with both dowel pins engaged into the receiver
pockets of the cup.
4. Fill ExpressLiner (2) with ink to desired fill level.
5. Place the ‘CLICHÉ’ (5) carefully with the image facing down. Slide cliché back until it is located firmly against
the back and side stops on the ‘SETUP TABLE’ (1)
6. Loosen thumb screws and carefully lift the ink cup/cliché assembly out of the SETUP TABLE
7. Remove the ink cup assembly from the ‘SETUP TABLE’ (1)
Turn the assembly over (the cliché is now on the bottom)
With side guard open, slide the assembly into the Aero Pad Printer.
8. Close the clamping lever (move counterclockwise) to clamp the ink cup
Verify that the clamping fingers are properly engaged with the hold down ring
9. Remove the MAGNETIC CUP CLAMPS
10. Mount pad onto magnetic holding base
11. Close machine guard
The machine is ready to operate
Thumb
Screw