Fig. 15: Check the lateral and height offset
4.
Check the lateral and height offset using a dial gauge:
n
Carry out measurement as shown.
n
In the event of a lateral or height offset: Align the motor
(
Chapter 5.5.5 ‘Aligning the motor’ on page 37
).
Permissible axial or radial deviation, measured on the front face of the
coupling or at the coupling circumference:
manufacturer's data.
Fig. 16: Checking the angular offset
5.
Check the angular offset with a dial gauge:
n
Carry out measurement as shown.
n
In the event of an angular offset: Align the motor (
‘Aligning the motor’ on page 37
).
6.
Check the coupling alignment again and correct the motor alignment if nec-
essary.
5.5.5 Aligning the motor
Necessary with an overly large or small clearance, or lateral, height
or angular offset.
1.
Align the motor such that the coupling halves are precisely flush, if neces-
sary position on shim plates.
2.
Check alignment.
3.
If the height offset is still evident: repeat the alignment process.
4.
Then tighten the motor screws.
Installation and connection
37
Type SLH-4U
0
3
/20
20
JP Rev. 1
