ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · [email protected] · www.ek.plus
CM 8SH-TC
USER MANUAL
programming via USB. Connect the module to the device using the power and data
cable. Connect the PC to the CM PR via USB cable.
6.- Run the PC SW programming.
power supply or the
and
power supply to the PC before running the software so that it is correctly
detected by the PC driver.
Installation of a multi-module head-end:
In the event of wishing to install the module as a further element of a head-end consisting of other CM
series modules it is very important to follow the instructions below.
•
Connect the different modules in series using the supplied power cable and then the power supply,
which must always be to the left of the head-end.
•
Check the consumption of the modules. In general, up to 5 modules can be connected using an FA 524
power supply. However, it is recommended to check the power consumptions of the modules to be
installed.
•
It is recommended to install the modules with CIs downstream of the power supply.
•
It is possible to use the long jumper to deliver the input signal to adjacent modules.
•
The attenuation at the output of each module can be adjusted to compensate for cable losses at high
frequency.
“CM Management” PROGRAMMING SOFTWARE
:
The “CM Management” programming software enables programming and
controlling all CM head-end
modules. The program is only available for Windows operating systems (version XP, 7 and higher). Once
downloaded from the website
, Software / CM Head-end section, run the program after
connecting the PC to the USB port of the FA 524 or CM PR power supply unit. This will ensure that the
driver detects the control panel.
Main screen:
The main screen of the “CM Management” software is
displayed as follows:
software version is installed.
It can be directly connected via USB or LAN.
