Itowa CTN, Руководство пользователя

Страница: 25 / 28

 
MINI RECEIVER
USER'S MANUAL
19
Incidences STATUS Solution
The machine is not
activated after a
change of working
channel.
The led lights up but
the receiver does not start.
Hold the transmitter run button pressed until
the receiver is switched on (max. 1 minute).
Do this as close to the receiver as possible.
With the transmitter at rest,
the receiver continues with
the led illuminated.
There are interferences in the new channel; it
should be switched to another channel.
The remote control
has little range and
the machine comes
to a complete stop,
but it allows you to
reset.
Antenna disconnected,
broken or in poor condition. Replace the antenna or contact the Technical
Support Service.
Even if the transmitter is
disconnected, by locking the
EMERGENCY STOP, the
receiver continues with the
led illuminated.
There are interferences from another device;
you must switch to another channel.
Randomly the
receiver is stopped or
some relays are not
activated, but the
receiver is still
running.
The receiver led stays
illuminated but makes a
quick pulse.
The power supply of the receiver is below
50% of the nominal.
The receiver led stays
illuminated but makes two
quick pulses.
The power supply of the receiver is below
45% of the nominal.
ATTENTION!: ORIGINAL SPARE PARTS MUST BE USED FOR ANY REPAIR
AND THE SAFETY FEATURES MUST NEVER BE ALTERED.