are warranted for
and maintained according to
y is limited to repair or replacement free
dent, misuse, tampering or lack of
ervice is required,
nts Office. If under warranty,
If the repair is not covered by
uthorization (RGA) number from the
any instrument, make sure it is
-Logger
to modify the design, construction or appearance
advance notice.
If the starting type was set to
PC Start
, then the
Start
key will
become active. Click to
Start
.
If the starting type was set to
Button Start
, then the logger
display will indicate that the logger button has to be pressed
to start logging. Keep the button pressed for about 3 seconds.
3 sec.
If the starting type was set to
Date/Time Start
, then the
logger will automatically start logging at the programmed time.
Button Functions
Pressing the logger button will give different outputs depending
on the logger status.
• If the logger is in “
WAIT TO LOG
” status, then pressing
the button will navigate through current measurement, high
and low alarm thresholds.
• If the logger is in “
LOG
” or “
LOG DONE
” status, then
pressing the button will navigate through current measure-
ment, maximum and minimum recorded values.
• If you keep the button pressed, after 2 seconds the display
will show alternatively (toggle every 2 seconds) the high
and low alarm thresholds.
keep pressed,
then after 2 sec.
toggle every
2 seconds
Notes:
•
If an alarm threshold has not been
set, then the logger will display the
“
diS
” (disabled) message.
•
If an alarm condition has occurred during logging, then
in the “
LOG
” or “
LOG DONE
” status the corresponding
alarm indication (
“ALARM HI
” or “
ALARM LO
”) will blink.
Operational Guide
Technical Service
This instrument is factory calibrated, but it is generally
recommended to have all thermometers recalibrated at least
once a year.
Initial Operation
The logger is supplied complete with a CR2032 lithium battery.
Open the battery compartment cover (see “Battery Replacement”
section for details), insert the battery with the + sign facing
up and tighten back the compartment cover.
The display will show the
“PC”
message
to indicate that the logger needs to be
programmed through a PC.
Startup
In order to communicate with the logger, the application
software must be installed on your PC.
Connect
HI144002
communication cradle to your computer
through a USB port, and place the
HI144
on the cradle.
Run the application software. The yellow LED on the cradle
blinks to indicate that the communication is active.
Do not
remove the logger while the LED is blinking
.
The following operating parameters can be set:
• Measurement Unit: °C or °F
• Starting Type: PC Start, Button Start or Date/Time Start
(hh:mm:ss)
• Logging Method: Wrap Around Memory, until memory is full (at
8000 samples) or number of samples (a maximum of 8000)
• Logging Interval: from 1 minute to 24 hours (1 minute
resolution)
• High and Low Alarm thresholds
• Logger Password
Click on the
Program
key to program the logger with the
selected options.
www.
.com
1.800.561.8187
