BM18A OPERATOR’S MANUAL
www.itmtools.com.au
23
BM-18
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
23
Lightly tighten the levers (
1
) to install the vertical clamp (
2
). Move the clamp to
the workpiece (
3
) and tighten the levers in this position (
4
). Next, remove the wor
k-
piece and set the required
bevel parameters. Then, use the 5
mm hex wrench to
tighten the screws (
5
) to attach
the machine.
Start the machine and set the required rotational speed. Then, put the workpiece
on the left and bevel in the direction (
6
).
3
2
1
5
6
4
