BM18A OPERATOR’S MANUAL
www.itmtools.com.au
13
BM-18
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
13
3.6. Replacing the cutting inserts
Unplug the power cord. Loosen the screw (
1
)
and turn
the sleeve (
2
) to lower it as far
as possible and
get access to the milling head.
Use the T15 torx screwdriver
to
remove the cu
t
ting insert
s (
3
,
4
). Clean the socket
s.
To change the cutting edge, remove
the insert
s
and turn them
by 90° or 180°
.
Then
,
push
them to the sockets
and tighten. If all the cutting
edges are worn
,
install
new
i
nserts. Make sure that the bottom of each insert is in full contact with the
socket (
5
)
.
Each week clean the threads of the mounting screws for inserts and put the
sup
plied grease on the threads.
1
2
4
INCORRECT
×
CORRECT
✓
3
5
