325
EN-15
This value will be automatically update if a lower
value will occur.
4. Pressing again the MAX/MIN key less than 1
second, the blinking message “MAX MIN” will
appear on the display. In this mode the clamp
measures and store the minimum and the
maximum values of the selected quantity. To get
the minimum or maximum stored value press less
than 1 second the MAX/MIN key until the display
shows the desired quantity.
The MAX/MIN function will be disable if:
l
The MAX/MIN is pressed for more than 1 second.
l
The position of the rotary switch is changed.
?
PEAK –H (PEAK HOLD) function
1. Set the rotary switch to V /A range.
2. Set the PEAK-H mode by pressing the PEAK-H >2
sec, The PEAK-H function will enter to calibration
mode, the LCD will show “CAL” and the internal
buffer will remember the internal OP offset voltage
then back to the 600V or 600A range.
3. The display shows Pmax to indicate the PEAK
MAX and shows Pmin to indicate the PEAK MIN.
(See Fi g 4)
*
Under PEAK-H, the bargraph always show current
value.
www.
.com
1.800.561.8187
