Page 2
ELM 4-Button Keychain Touchpad
8)
Repeat 7 a, b, and c until all ELM Keychain
Touchpads are learned.
9)
Exit programming mode.
Testing Keychain Touchpad
Operation
Test Keychain Touchpad operation by pressing the
buttons as described below:
1)
Unlock Button - disarms system to level 1.
2)
Lock Button -
■
panel attempts arming from level 1 to level 2 or
from level 2 to level 3.
If protesting, the panel responds as if BYPASS
was pressed.
■
panel arms directly to level 3, with no delay.
If protesting, the panel responds as if BYPASS
was pressed.
3)
Lock and Unlock Buttons Together - panel
responds with an alarm condition (police or aux-
iliary), based on the sensor group the touchpad is
learned into.
4)
Star Button - panel or SnapCard output activates
based on output configuration setting.
Troubleshooting
Table 1 describes what to do if you experience trouble
with Keychain Touchpad programming or operation.
Specifications
Compatibility: Concord Express
Power Requirements: 12V 33 mAh Alkaline Battery
Range: At least 500’ open air
Dimensions: L = 2.30” x W = 1.45” x H = .48”
Notices
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may
cause undesired operation. FCC ID No. B4Z-760A-EFOB.
Changes or modifications not expressly approved by Interactive Technologies, Inc. can
void the users’ authority to operate the equipment
ITI is a registered trademarks of Interactive Technologies, Inc. ELM, Concord and Snap-
Card are trademarks of Interactive Technologies, Inc.
Table 1. Troubleshooting
Problem
Action/Solution
Touchpad does not learn
(alphanumeric touchpad
display does not advance
to next available sensor
number).
Make sure Keychain
Touchpad LED does not
blink during quick press
and release.
Panel does not respond to
Keychain Touchpad sig-
nals.
1. Check panel memory to
verify panel learned the
touchpad. Repeat learn-
ing procedure if neces-
sary.
2. Touchpad is out of sync
with panel (caused by
64 or more touchpad
button activations out
of panel receiving
range). Resync touch-
pad and panel by enter-
ing sensor test mode
and pressing the lock
and unlock buttons
together.
Table 1. Troubleshooting (Continued)
Problem
Action/Solution
6 5 1 / 7 7 7 - 2 6 9 0
6 5 1 / 7 7 9 - 4 8 9 0
