I
NFRARED
E
MITTER
P
LATE
12 Volt Battery Pack
1. Remove power cord from battery pack storage pouch.
2. Insert power cord plug into receptacle on Infrared Emitter Plate by rotating it until it locks into place.
Charging the 12 Volt Battery Pack
1. Disconnect power cord plug from Infrared Emitter Plate.
2. Insert power cord plug into Battery Charger receptacle.
3. Plug Battery Charger into a 110VAC/ 60Hz wall outlet. Allow 12-16 hours for battery to fully recharge.
AC Power Supply
1. Plug Power Supply into a 110VAC/ 60Hz wall outlet.
2. Insert power cord plug into receptacle on Infrared Emitter Plate by rotating it until it locks into place.
Operating Infrared Emitter Plate
1. Hold Infrared Emitter Plate by black plastic housing, flat side down. Slide distal end of plate underneath door.
2. Slide or pivot Infrared Emitter Plate around to vary intensity of Infrared light emitted into room.
3. To disconnect either AC Power Supply or 12-Volt Rechargeable Battery Pack from Infrared Emitter Plate, pull
back housing on power cord plug and remove from receptacle.
T
ELESCOPIC
A
RM
1. Securely screw threaded stud on Telescopic Arm into threaded hole provided on back of scope.
2. Turn Tension Adjust Ring to adjust amount of drag on rotary mount.
3. Fully extend Telescopic Arm until it locks into place.
4. Adjust Swivel Mount on Telescopic Arm by holding the scope firmly and pivoting the Arm.
5. Moving the handle on Telescopic Arm remotely adjusts location and viewing direction of scope.
6. To collapse Telescopic Arm, disengage lock by pulling back on handle logo ring. Guide arm into handle.