Ithaca Epic 950, Руководство по интеграции

Страница: 149 / 158

Command Reference Epic 950 OEM Integration Manual
95-05245
Rev G
Page 137
GS z – Request Printer Status
Description
This command returns a single status byte reflecting the printer status, which is
determined by testing the individual bits within the returned status byte. Do not test bits
designated as reserved. All sensor bits defined below are a debounced reading of the
hardware sensors.
For firmware compatibility with previous versions of your printer,
including Series 800 printers, an earlier status bit convention may be
selected at device initialization time via the
POR.INI file described in the
chapter Programming for the Epic 950 , with status bits interpreted as
documented below.
Expression
ASCII [GS] z
Hexadecimal 1DH 7AH
Decimal <29> <122>
Parameters None
Default format:
Bit
Bit = 0 Bit = 1
0 LSB Ticket not low Ticket low
1 Ticket not in printer Ticket in printer
1
2 Not Top of Form State Top of Form State
3 RESERVED This bit is always = 1
4 Bar Code not Completed Bar Code Completed
5 Validation not Completed Validation Completed
6 Ticket not in path Ticket in path
7 MSB No paper jam Paper Jam
Compatibility format:
When a compatibility mode for earlier printers is selected at device initialization, the
above byte will instead follow the format used in Series 800 printers prior to firmware
revision 8520. This mode is set using the
POR.INI file – this file is documented in the
chapter Programming for the Epic 950 . This format is as follows:
Bit Bit = 0 Bit = 1
0 LSB Ticket not low Ticket low
1
This status will also be cleared for a Inner Chassis Open or Head Up. Head Up and Inner
Chassis Open status are available on [GS] S command.