ITEM Linear Unit LRE 8 D14 80x40 KU 80, Заметки по использованию и установке

Страница: 11 / 14

11
F
max
=2000N
M=9Nm
27
15
60
L=2xS+H+376
160 S
12 12
S
L=2
xS+H+376
160
H
S
108
L = Gesamtlänge
in Abhängigkeit von Hub H
S = Sicherheitsabstand
Max. load
Linear Unit LRE 8 D14 80x40 KU 80
To fit Slide Stop LRE 8, first mark the desired end position on the support pro-
file of the linear axis. This position does not need to match the maximum travel,
but rather can be adapted to the transport task at hand.
The drawings and formulae can be used to help calculate the relevant end
positions when installing the Slide Stops in relation to travel. You can use both
sides of the support profile to install Slide Stop LRE 8.
In the case of Linear Units LRE with a rack drive, Slide Stop LRE 8 can only be
installed on the side opposite the Motor.
Roll the T-Slot Nuts into the groove under the shaft on the side where you are
going to install the Stop.
Use two screws (M6) to attach the basic unit, but do not tighten them at this
stage. When installing the basic unit, make sure the threads are facing toward
the Reverse Unit.
Next, slide the basic unit along the groove until the outside edge facing the
Reverse Unit is in line with the mark you made earlier and then tighten with the
appropriate torque.
Finally, use two M6 screws to attach the Slide Stop to the basic unit and tighten
with the appropriate torque – M = 9 Nm.