5. Stand Installation
1. Unpack the carton, take out the upper and lower covers of Styrofoam, and lay it
flat on the desktop. Remove the top cover of Styrofoam, then take the body out of
the film-coated bag and place it in the cavity of the lower cover of Styrofoam again.
Styrofoam
During taking out the monitor,
please start from the slot on the ground side
2. Take out the bracket and base, and lock them with three PM5*15mm screws
(One extra spare screw is provided), as shown in the figure below.
PM5'15ScrewsX3 -�
Stem
Base
3. As shown in the figure above, put the base assembly assembled in step 2 into the
corresponding slot of the rear case, gently press the bracket to fit the shaft assem
bly into the lock, and then hold the middle of the bracket and lift it up twice, and
tripped to ensure that the buckle can lock the base assembly. When disassembling,
follow the reverse steps.
®
Make sure the monitor is laid on a flat surface before removing the stand.
Eng-4
