Advanced Settings
40
Network
Make the network setting.
•
When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically. ("Enable" is set by default) To assign fixed IP addresses to each
components, you must set "DHCP" to "Disable" and assign an address to this unit in
"IP Address" as well as set information related to your LAN, such as Subnet Mask and
Gateway.
Setting Item
Default Value
Setting Details
Network Standby
Off
You can turn on the power of the unit via network
using an application such as Integra/Onkyo
Remote.
"On": Use this function
"Off": Do not use this function
•
When "Network Standby" is used, the power
consumption increases even when the unit
is on standby. However, the increase in
power consumption is kept to a minimum by
automatically entering the HYBRID STANDBY
mode, where only the essential circuit is
operating.
Wi-Fi
Off(Wired)
Connect the unit to network via wireless LAN
router.
"On": Wireless LAN connection
"Off(Wired)": Wired LAN connection
Wi-Fi Setup
–
You can configure wireless LAN settings by
pressing Enter when "Start" is displayed.
Wi-Fi Status
–
The information of the connected access point
will be displayed.
"SSID": SSID of the connected access point.
"Security": Security method of the connected
access point.
"Signal": Signal strength of the connected access
point.
"Status": Status of the connected access point.
MAC Address
–
This is the MAC address of the AV receiver.
This value is specific to the component and
cannot be changed.
Setting Item
Default Value
Setting Details
DHCP
Enable
"Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
•
If selecting "Disable", you must set "IP
Address", "Subnet Mask", "Gateway", and
"DNS Server" manually.
IP Address
–
Displays/Sets the IP address.
Subnet Mask
–
Displays/Sets the subnet mask.
Gateway
–
Displays/Sets the gateway.
DNS Server
–
Displays/Sets the primary DNS server.
Proxy URL
–
Displays/Sets the proxy server URL.
Proxy Port
–
Displays/Sets the proxy server port number when
you enter "Proxy URL".
Network Check
–
You can check the network connection.
Press Enter when "Start" is displayed.
•
Wait for a while if "Network" cannot be selected. It will appear when the network function is started up.
Bluetooth
Setting Item
Default Value
Setting Details
Bluetooth
On
Select whether or not to use the Bluetooth
function.
"On": Enables connection with a Bluetooth-
enabled device by using the Bluetooth function.
Select "On" also when making various Bluetooth
settings.
"Off": When not using the Bluetooth function
Direct Change
On
The input of the unit will automatically be
switched to "BLUETOOTH" when connection is
made from a Bluetooth-enabled device to the
unit.
"On": The input will automatically become
"BLUETOOTH" when a Bluetooth-enabled
device is connected.
"Off": The function is disabled.
•
If the input is not switched automatically, set
to "Off" and change the input manually.
