Itec 4000, Руководство пользователя

Страница: 16 / 20

16
Disassembly/Assembly
Assembly
Refer to Tools & Workspace from Disassembly Section
Installing the FRONT GRILLE:
1. Gently put the Front Grille in place on the front of the unit, being careful
not to damage the Ionization Needle at the top center of the front of the unit.
2. Insert the four Front Grille Screws one at a time until they are in place, but
not tight. After all four Front Grille Screws are in place, tighten them carefully.
Installing the PCO CELL:
1. Position the PCO Cell inside the unit so that the two tabs are on the bottom
(and interior side) of the PCO Cell . Ensure the holes in the two tabs fit over
the two Screw Posts . Screw the Thumb Nuts onto the Screw Posts until they
are snug.
2. Align the PCO Cell Power Connector to the PCO Cell Power Connector Outlet
and insert gently until the tabs at the top and bottom of the PCO Cell Power
Connector snap into place, holding it in the PCO Cell Power Connector Outlet .
Installing the PURIFICATION PLATE:
1. Holding the Purification Plate by the ceramic, slowly insert it into the
Purification Plate Slot , ensuring that the Purification Plate is sliding into the
grooves on either side.
NOTE:
About halfway in, the Purification Plate Connectors are parted.
Continue sliding the Purification Plate into the Purification Plate Slot until there
is approximately one inch of the Purification Plate remaining outside of the
Purification Plate Slot and significant resistance is met. Be careful not to force
the Purification Plate further into the Purification Plate Slot as this could seriously
damage your unit.
Installing the FILTER ASSEMBLY:
1. Hold the Filter Assembly with the larger flat side (where the honeycomb
layer of the filter is visible) facing the interior of the unit. A sticker reading,
“Caution: Reinstall Filter After Cleaning,” is located on the opposite side
of the Filter Assembly . This sticker should be visible when you install the
Filter Assembly .
2. Insert the bottom of the Filter Assembly into the tabs on the rear of the unit
and then seat the Filter Assembly on the rear of the unit. (NOTE: If the user
fails to insert the Filter Assembly into the tabs appropriately, disassembling
the unit in the future could be extremely difficult.)
3. Screw the two Brass Thumbscrews into their holes at the top corners of
the Filter Assembly .
Installing the Rear Cover:
1. Place the tab at the top of the Rear Cover into the hole at the top of the Filter
Assembly then lay the Rear Cover flat against the rear of the unit until the tabs
on the sides of the Rear Cover click into place on the unit.
2. Carefully insert the Rear Cover Screw into its hole on the Rear Cover (above
the Power Cord Port ) and tighten.
Installing the POWER CORD:
1. Insert the Power Adapter Plug into the rear of the unit.
2. Ensure the Power Cord is properly connected to the Power Adapter .
3. Insert the Power Plug into a wall outlet.
Turning the unit on:
1. Press the power button.
2. The unit will be set to Normal Mode once again. Ensure that the unit’s settings are
adjusted to suit the environment (see “ Operations” on page 13).