4
ENGLISH
FUNCTIONAL DESCRIPTION
A.
Variable speed trigger
B.
Forward / Reverse switch
C.
3/8" Keyed chuck
D.
Hole for chuck key insertion
E.
Trigger-lock button
F.
Rubber grip handle
G.
Motor brush dust cover cap
OPERATING THE CHUCK
Be sure the drill is disconnected from power.
Open the chuck, using the chuck key, until it accepts the drill bit or accessory shaft,
up to 3/8" (10 mm) in diameter.
Close the chuck and tighten it using the chuck key in all three holes in the chuck.
Remove the chuck key before using.
RUNNING THE TOOL
1. Plug in the tool.
2. Hold the tool firmly. Squeezing the trigger more will increase the speed.
3. To maintain speed, engage the trigger-lock button on the left side of the handle
when squeezing the trigger switch.
4. To disengage the trigger-lock button, squeeze the trigger.
To change the chuck rotation direction, move the rotation direction switch above
the trigger to the other side. Setting the direction switch to the right causes the
drill to turn clockwise, for normal drilling. The direction switch moved to the left will
cause the drill to run in reverse (counterclockwise) direction, backing drill bits and
screws out screws out of their holes.
Warning:
Turn off your drill at once, unplug and inspect it for serious problems if:
n
Moving parts get stuck
n
Speed drops to an abnormally low level
n
The motor housing gets hot
n
Sparks or odours emit from the casing
Metal Drilling
Use a sharp drill bit especially designed to cut the material you are working on. It is
recommended you use a cutting fluid on the metal surface to avoid heat build-up.
!
OPERATING PROCEDURES