ITC SPT140, Руководство оператора

Страница: 6 / 15

ENGLISH
FRANÇAIS
MAINTENANCE

Keep the vents clear of dust and debris. This will help prevent possible
electrical shorts and ensure proper cooling.

Keep the tool housing clean and free of oil and grease using mild soap and a
damp (not wet) cloth.

Avoid overloading your sander. It will become hot and lose efficiency.
Running it free of load for a minute or two will allow it to cool itself to normal
temperature.

Inspect the cord regularly and have it replaced by an authorized repair facility
if it is damaged.

Lubrication for this tool is done at the factory and should not be necessary
again under normal use.

An authorized repair centre should do any repairs, modification, or
maintenance that involve disassembling the tool.

Any damage to the tool should be corrected at an authorized repair centre.
PARTS LIST
Part No. Description
1 Bearing cover
2 Bearing 626
3 Gear shaft
4 Bearing 608
5 Dust suction cover
6 Fan
7 Screw ST3.8 x 16
8 Washer
9 Cover plate
10 Belt wheel
11 Belt cover
12 Inductance
1 Capacitor
14 Cable cover
15 Power cord
16 Screw ST4 x 18
17 Strain relief
18 Left housing
19 Bearing 6000
20 Washer
21 Big gear
22 Pin
23 Safety ring
24 Nameplate
25 Brush holder
26 Nut
27 Carbon brush
28 Brush cover
29 Washer
30 Spring
31 Adjustment knob
2 Pin
33 Screw ST4.8 x 20
4 Copper sleeve
Part No. Description
35 Washer
36 Rear pulley
37 Washer
38 Screw M5 x 10
39 Washer
40 Baffle
41 Spring
42 Screw M4 x 10
43 Bearing seat
44 Front cover
45 Screw ST4.8 x 18
46 Sanding belt
47 Rubber base plate
48 Steel base plate
49 Drive belt
50 Safety ring
51 Washer
52 Driven axis
53 Shelf assembly
54 Front idler pulley
55 Small gear
56 Stator
57 Bearing 608
58 Rotor
59 Bearing 608
60 Right housing
61 Screw ST4.8 X 20
62 Specification plate
63 Screw ST4.8 x 40
64 Screw ST4.8 X 25
65 Screw M5 x 40
66 Switch
67 Soft overlay
Please refer to the schematic drawing on page 15.