ITC 024852, Руководство оператора

Страница: 2 / 12

E
NGL
IS
H
2
Thank you for purchasing an ITC pallet truck. Your pallet truck is made of high quality steel and was
designed to give you a durable, reliable and easy to use product. With proper maintenance, your ITC
pallet truck will give you years of trouble-free operation.
WARRANTY POLICY
Your ITC pallet truck is backed by a nationwide network of distributors and authorized repair stations.
It is guaranteed to be free from defects in materials and workmanship. ITC pallet trucks that fail during
the first year of operation due to such defects will be repaired or replaced at our discretion. Normal
wear and tear on moving parts and seals is excluded from this guarantee.This guarantee does not
apply to any product showing signs of misuse, overloading, alteration, or improper maintenance.
WARRANTY PROCEDURE
After receiving authorization from one of our offices, any product for which there is a warranty claim
must be returned prepaid to an authorized warranty depot along with proof of purchase.
1. GENERAL SPECIFICATIONS -
PROD. NO. 024852 (MODEL IPT-55A)
Capacity
5,500 lb/2,500 kg
Fork Length
48
"
/1,220 mm
Width 27
"
/685 mm Min/Max Ht. 2.95/7.25
"
, 75/185 mm
Weight 198 lb/90 kg
2. TO ATTACH HANDLE TO PUMP UNIT
2.1 Insert handle onto pump piston (303), then use a hammer to insert the axle with hole (105)
through the pump and handle from right side to left until split pin seats in groove on pump
body (see Fig. 2). Note this axle has two split pins (106), one is pre-inserted into the axle,
the other is applied in step 2.5. Axle and pins are in plastic bag attached to handle.
2.2 Set control lever on handle to “ LOWER ” position, then pass adjusting nut (104),
adjusting bolt (103), and chain (102) through hole in axle (105) (see Fig. 3).
2.3 Push handle down and remove retainer pin #2 (see Fig. 1).
2.4 Set control lever to “ LIFT ” position, then raise lever plate (319) using pin #2 and insert
adjusting bolt (103) into the slot in the front of lever plate (319). Ensure adjusting nut (104)
is on underside of plate (319).
2.5 Use a hammer to tap second split pin (106) into axle (105).
Fig. 1
1. Handle
2. Retainer Pin
3. Axle with hole
4. Split pin
5. Fork Frame
Fig. 2 Fig. 3