Italora Smart 2000 EL7, Руководство пользователя

Страница: 5 / 21

S 2000/2001GM/3001GM EL7
5
5. MAIN COMPARTMENT DESCRIPTION
(see following picture)
10 - photosensor for end of roll and label
synchronisation
15 - rewinding shaft with adjusting clutch
18 - print head position fine adjustment
21 - rubber feeding roll
23 - print head assembly pressure spring
25 - lock / unlock lever
25a - working position
25b - open position
29 - thermal ribbon rewinder
30 - thermal ribbon stock
32 - label guide arm
33 - pressure clip
35 - front cover
45 - label unwind holder
48 - photosensor for end of thermal ribbon
105 - print head assembly
25c - cleaning position
21 29 105 18 23 25b 25a 30 33 15 32 45
35 10 48
25c
PICTURE 6
6. INCOMING INSPECTION
* Open the main compartment.
* Check the presence of the label roll and of the
thermal ribbon roll.
* Check the correct pinout of the serial I/O Cannon 9
pins female connector (or of the USB connector) and
connect the printer to the computer.
* For further details see chapter "Connection to
Host Computer".
* Check the voltage on the name plate next to the
power receptacle.
* Connect the power cable to a grounded power line
* Lift the printhead down by rotating the lever #25a.
* Switch the main switch on (rear panel)
RED and GREEN leds ON mean operating
conditions.
* Push the PRINT (ENTER) BUTTON, you will get a
printing test with the FIRMWARE release
information.
* Sending data from the computer you will get the
first printing.
* Push the PRINT (ENTER) BUTTON to get the
last printing again; the printer keeps the information
of the last printing until next data arrive.
NOTE: Printer retains the label length and the backing paper transparency in permanent memory.
In case of change of print media see the following paragraph.