Italora Smart 2000 EL7, Руководство пользователя

Страница: 7 / 21

S 2000/2001GM/3001GM EL7
7
8.2. LABEL ROLL REPLACEMENT
In case of changing of label format or printing media type, remember to follow the "Label format set up
procedure" shown on paragraph 6.1.
8.2.1. DISPENSING MODE
(see picture 8)
Open side of printer.
Remove the empty label roll.
Lift guide arm #32.
Insert new label roll onto roller #45
Bring the guide arm #32 down and push it tightly
against the side of the label roll.
By rotating the lever #25b, lift the printing head #105
from the feed roller #21, setting the movement of
labels and ribbon free.
Remove clip #28 from the rewinding shaft #15.
Remove backing paper from the rewinding shaft. Remove the first 50 centimetres from liner of the new
roll labels.
Hold pressure clip #33 up and feed the liner through
the path, slide it on the rewinder unit #15 and
fasten it with the clip holder #28.
Turn the rewinder to stretch the paper.
Turn head lever back to closed position #25a.
Check paper has been rightly positioned under
the label photosensor #10.
Check pressure clip #33 has been positioned between
centre and outer side of the label.
Close side of printer.
8.2.2. STRIP FORM MODE
(see picture 9)
Open side of printer.
Remove the empty label roll.
Lift up the guide arm #32.
Insert new label roll onto roller #45
Bring the guide arm #32 down and push it tightly
against the side of the label roll.
By rotating the lever #25b, lift the printing head #105
from the feed roller #21, setting the movement of
labels and ribbon free. Hold pressure clip #33 up and feed the paper through
the path.
Turn head lever back to closed position #25a.
Check paper has been rightly positioned under
the label photosensor #10.
Check pressure clip #33 has been positioned between
centre and outer side of the label.
Close side of printer.
8.2.3. REWINDING MODE
(see pictures 10 and 11)
Is necessary to rewind printed labels inside to remove
the plate #20, turning the screws #139,140 out.
Open side of printer.
Remove the empty label roll.
Lift guide arm #32.
Insert new label roll onto roller #45
Bring the guide arm #32 down and push it tightly
against the side of the label roll.
By rotating the lever #25b, lift the printing head #105
from the feed roller #21, setting the movement of
labels and ribbon free Remove clip #28 from the rewinding shaft #15.
Hold pressure clip #33 up and feed the paper through
the path, slide it on the rewinder unit #15 and
fasten it with the clip holder #28.
Turn the rewinder to stretch the paper.
Turn head lever back to closed position #25a.
Check paper has been rightly positioned under
the label photosensor #10.
Check pressure clip #33 has been positioned between
centre and outer side of the label.
Close side of printer.