Italkero INFRA Spider, Руководство пользователя и инструкции по сборке

Страница: 20 / 36

GENERAL DESCRIPTION
Due to its specific type of operation with direct and reflected radiation, this appliance permits hea-
ting a surface of around 20/25 m2 (Fig. 1), naturally in environments with good fresh air ventila-
tion, for example: terraces, pergolas, restaurants, cafés and open-air installations (gardens, pave-
ments, etc).
IMPORTANT! In all installation conditions, adequate covering must be provided to protect the
appliance against the weather.
The appliance is very simple to use and built according to CE safety standards. It has been tested,
approved and is controlled by the Notified Approval Institute to which the Manufacturer has always
entrusted most of its certifications in the gas industry.
Types of installation:
- WALL-MOUNTED
, by means of a corner bracket (accessory);
- FASTENED TO CEILING
, by means of a retention plate (accessory);
IMPORTANT! These two types of installation must only be made by professionally qualified person-
nel, using Propane/Butane gas (cylinder or mains gas) or mains natural gas.
IMPORTANT! This appliance can ONLY BE INSTALLED UNDER FIXED OR MOBILE COVERINGS, to
protect it against rain and water infiltrations which could seriously damage it and represent a
hazard. The Manufacturer disclaims all liability for any injury to persons or animals and damage
to things caused by improper use and the infiltration of water resulting from failure to place the
appliance under a covering.
ASSEMBLY
Take all the parts making up the appliance out of the packaging, with special care given to the bur-
ner unit (Fig. 6: 15).
First, check the integrity and the conformity of the contents of the packaging (the latter must be
disposed of according to applicable regulations).
Check the contents of the PACKAGING
A – Fig. 2 = burner unit, bag with 1 diaphragm for LPG, with Allen instruction leaflet
B: Fig. 2 = Cover dish and retention screws.
IMPORTANT! IN CASE OF DAMAGE TO THE PARTS DO NOT GO AHEAD WITH ASSEMBLY!
“SPIDER” ASSEMBLY OPERATIONS (FIXED wall or ceiling mounted with LPG cylinder or mains gas):
IMPORTANT! Before starting installation, make sure that underneath the retention flange, there
are NO chases, power wires, water or gas pipes.
IMPORTANT! Before starting assembly, make sure the parts making up the appliance are set for
the type of gas and the operating pressure indicated by applicable regulations.
20
S U N f o x I N F R A S p i d e r r e m o t e