Italiana Camini Dida Idro, Инструкция по установке, эксплуатации и обслуживанию

Страница: 16 / 28

16
ENGLISH
cHecKing tHe electRical connections
(the power socket must be located in an
easy to access position)
The boiler stove is equipped with an electrical power
cable for connection to a 230V 50 Hz socket, preferably
with a circuit-breaker.
Variations in voltage of more than 10% can affect the
operation of the boiler stove.
The electrical system must be compliant; check the
operation of the earth in particular.
The manufacturer is not responsible for malfunctions
due to an improperly grounded system.
The power line must be of adequate section for the
power of the appliance.
The power cable must not come into contact with the
flue or other hot parts of the boiler stove.
Supply power to the boiler stove by moving the switch
on the back from 0 to 1.
There are two 2 A fuses on the socket with switch
located at the rear of the stove.
Vent
When performing first ignition, vent both air and water
through the manual valve (V) located on the front of
the top.
To access, lift the ceramic top.
The operation must also be repeated during the
first few days of use
and if the plant has also been
partially reloaded. The presence of air in the ducts
does not allow it to function properly.
To help with venting operations, the valve is equipped
with a rubber tube.
installation
fiRst ignition (coMMissioning) PHases
• Make sure you have read and understood this
manual
• Remove all flammable materials from the appliance
(manuals, labels, etc). In particular remove any
labels from the glass.
On first ignition, there may be a slight smell of paint,
which will disappear in a short time.
Loading the peLLets into the tank.
To access the tank, open the lid *
Use UNI EN ISO 17225-2 category A1 wood pellets
or similar regulatory products with the following
characteristics.
diameter 6 mm
length 3-4 cm
humidity <10 %
For reasons of safety and protecting the environment,
DO NOT burn plastic, painted wood, coal, bark or
other such materials in the stove.
Do not use the boiler stove as an incinerator.
Caution
Using fuels other than those specified can
damage the appliance
1) During this operation neVeR
PUt the sack of pellets on the
ceramic top, as the plastic sack
may ruin it with the heat.
2) Use the provided gloves when
loading the boiler stove while it
is operating and therefore hot to
touch.
®
*
Fig. 2
V