iSystem IC50130, Руководство пользователя

Страница: 8 / 22

5
6-pin 2.54mm NXP S12Z BDM Debug Adapter
Ordering code IC50141
This debug adapter is used to connect the iC5000 and the iC5700 BlueBox to NXP S12Z based
target featuring 6-pin 2.54mm pitch target debug connector with the S12Z BDM pinout.
The debug adapter connects to the 25cm 40-pin ribbon cable coming from the BlueBox and to
the target debug connector on the other side. Refer to the BlueBox User Manual for more
details on connecting the debug adapter.
The following pinout is valid on the target side:
Signal direction Signal Pin Pin Signal Signal direction
I/O BGND 1 2 GND
I PDO 3 4 RESET I/O
I PDOCLK 5 6 VTref I
6-pin S12Z BDM pinout
When connecting the BlueBox to the new embedded target for the first time, double
check that the debug adapter pinout matches with the target debug connector. Note
that a mismatch can result in a hardware failure.
6-pin NXP BDM Debug Adapter features resettable fuses on pins 1, 2, 4 and 6. These fuses
protect debug signals against overcurrent and cycle back to a conductive state after the
excessive current fades away. Signals on pins 3 and 5 are protected via 47 ohm serial resistors
The debug adapter connects to the target via a 6-pin 2.54 mm connector, for example FCI
71600-006LF. A target should feature a matching part, for example WÜRTH ELEKTRONIK
61200621621.