4
Seebacher GmbH
www.seebacher.de
Phone: +49 (0) 80 41 / 77 77 6
Marktstrasse 57, 83646 Bad Tölz
Fax: +49 (0) 80 41 / 77 77 2
6. Maintenance / Care / Disposal
The product is maintenance-free.
The device has highly sensitive
sensors and lens systems
. Soiled devices can be cleaned with a
dry wipe. If this is not sufficient, a wipe slightly moistened with soap-
water mixture can be used.
Do not clean the lens system with
abrasive or aggressive cleaning products
.
Disposal (European Union)
Do not dispose of product in household waste! Products with this
symbol
7. Storage
The product must be stored in a dry place, protected from dirt and
mechanical stress. After damp or dirty storage, the product may only
be operated after a condition check by an authorised electrician.
8. Assembly
(Only by certified electrician!)
Mount the product only when it is in a power-free state!
Switch off the power supply, check that there is no voltage, secure
against being switched on again!
The device may only be operated at voltages according to the tech-
nical data and loaded with the currents defined therein. Only use
suitable equipment (system modules).
Check that there are no loose parts in the product. If this is the case
and the presence of such parts is not explicitly described, do not
install or commission the product.
Only use suitable cables and fixing screws.
Assembly site
• The product can be installed in any position in a casing to be deter
-
mined by the electrician (junction box). Observe maximum ambient
temperature!
Assembly steps
(Read completely before assembly!)
The device is designed for wall or ceiling mounting. The full functio-
nality of the device depends, among other things, on the mounting
height (see chapter „Detection range“).
• Mount the device in a suitable casing.
• Make the electrical connections according to the wiring diagram.
• Only after a complete connection and a visual test by a qualified
electrician, the system may be put under voltage.
Seebacher GmbH
Marktstrasse 57
83646 Bad Tölz
GERMANY
Phone: +49 (0) 80 41 / 77 77 6
Fax: +49 (0) 80 41 / 77 77 2
www.seebacher.de
[email protected]
5. Service address
4. Declaration of Conformity
The valid declaration of conformity for the module can be requested
from us free of charge by stating type and article no. as follows:
By phone:
+49(0)8041/77776
By fax:
+49(0)8041/77772
By mail:
3. Warranty
We provide warranty within the framework of the statutory provisi-
ons. These are limited to the intended use of the module and refer
to the repair or replacement of the ISYGLT module. Please send the
device with an attached error description to our company address
given below.
must be disposed of according to the EU directive WEEE 2012/19/
EU on waste electrical and electronic equipment at the local collec-
tion points for waste electrical and electronic equipment!
