ENGINE OPERATION
54
STARTING ENGINE
Use the following procedure to start the engine.
Note that two typical operator’s consoles are shown
for illustrative purposes only.
1. Make sure you follow the procedures stated in
2. Before first starting electronically controlled
engines 3CE1: The E-ECU of the electronically
controlled engines shown above needs to be
initialized at initial power up. When the fault
indicator comes on at initial power up, the
E-ECU has finished initialization. Then always
turn the key switch to the OFF position once
before starting the engine. (The E-ECU has
usually been initialized before the driven
machine is delivered).
From the second power up, make sure the fault
indicator is on for 2 sec. when turning the key
switch to the ON position.
3. Make sure the water separator fuel valve
(Figure 1, (1)) is in the ON position
(Figure 1, (2)).
Figure 1
4. Set the transmission (if equipped) in the
NEUTRAL position.
5. Disengage the PTO (if equipped).
6. Set the engine speed control to the
mid-position.
Figure 2
NOTICE
Never use an engine starting aid such as ether.
Engine damage will result.
7. Insert the key into the key switch (Figure 2, (1))
or (Figure 3, (1)).
c
o
1
2
K0000655A
K0000012B
1
2
AUX
K0000009BX
3
1
2
4
TNV_OperationManual_T4(under 19kW).book Page 54 Wednesday, June 17, 2015 11:23 AM
