14
TROUBLESHOOTING
•
BUTTONS DO NOT WORK
Check the correct positioning of the camera;
• BUTTONS GET STUCK
Apply lubricant to the button. Press the button several times to
distribute the lubricant.
N.B.*
Don’t use vaseline grease on the O-rings seals.
We recommend the use of original
ISOTTA
products.
• TRACES OF SALT ON JOINTS WHILE ASSEMBLY HOUSING
Salty water on the joints: rinse well and wipe the points with
Vaseline oil, except for the optics, which should be cleaned only
with special detergents.
• RED LED IS ON
A red
LED signal
indicates excessive moisture inside the housing.
If this happens underwater, you should get out of water as soon as
possible in respect of security measures and ensure that there were
no leaks.
In the event that there have been an infiltration, remove the sensor’s
battery, dry immediately with a soft cloth or a hair dryer. At this point,
the case will continue to operate.
In the event that, once dry the housing and insert a new battery, the
red
LED
continues to flash, this result in no problems for the mechanical
operation of the product.
As for the camera, please refer to the instruction manual of the camera.
In this cases it is advisable to send the case to the manufacturer for
verification.
