12
MOUNTING THE PORT
Included with the case is provided a flat port in
tempered glass
that,
depending on the camera model you choose and his lens, can be fixed
or removable.
Recognize which kind of port you need for your camera is simple. It is
sufficient to check if there is a lock in the camera lens.
In the event that the camera foresaw a housing with removable lens, the
following instructions will enable you to use this feature optimally.
The port is inserted and removed by means of a bayonet mount and the
housing is provided with a secure lock for a optimal sealing.
To perform the insertion and desinsertion of the port is necessary to
support the housing with the back placed on a hard surface and make
sure you have a good grip on it.
To remove it is sufficient unlock the safe lock by applying a gentle
traction to the outside and unscrew the port counter-clockwise until the
alignment of the markers placed on both sides and remove it.
Each time you do this it is necessary to pay particular attention to the
o-ring present on the extracted part that must be kept clean, undamaged
and properly lubricated.
To mount it just place the port at the front housing aligning the two
marks, apply a gentle pressure to match up the ends of the two devices
and screw it clockwise while maintaining the pressure until it reaches
a complete closure, recognizable thanks to the snap of the secure lock.
At this point the port is properly installed and you can proceed with the
placement of the camera and the closing of the housing.
The round ports, which are fixed or removable, ends with an
M67 thread
,
this thread in the porthole allow to use additional lenses and other
accessories with this kind of thread.
The use of these accessories is also possible with the rectangular
portholes with the purchasing an optional adapter.
All portholes provided are designed to accommodate the opal diffuser for
better light propagation and for a proper use of the built-in strobe.
