21
•
CHECK
the housing before installing the camera after dispatch or transport it by plane.
•
DON’T TRANSPORT
the housing hermetically sealed on a plane. Always remove
the port or the rear cap or the rear cap’s o-rings. If you remove the O-rings, then
remember to put them back on.
•
MAKE SURE
above all of the integrity of the seal between the back door and O-rings.
•
LUBRICATE
with a minimal amount of silicone grease the two O-rings located on
the rear cap.
•
DON’T CARRY
the housing with the camera placed inside to avoid stress to the
camera itself.
•
NEVER EXPOSE
the case in direct sunlight, as the color might fade and in order to
prevent damage to the internal circuitry.
•
CHECK
that the port is always clean (never degrease it with solvents, acetone,
paint thinner, etc. to avoid serious damage to the optical treatment). Only clean it
with liquid, cloths or optical cloths.
•
AVOID
sharp blows on the command buttons, front lens and ports.
•
AT THE END
of each dive rinse the housing in fresh water.
CAUTION:
rinse and dry the lens, in order to avoid chalky deposit formations that
over time would ruin irremediably the optics and the housing.
N.B.
*
: KEEP THE HOUSING TIGHTLY CLOSED when you rinse it.
Before removing the camera from the housing make sure the housing is dry to avoid
that any drop of water causes damage to the camera.
WARNINGS
