18
You can use the external flashes with the following modalities:
With OPTICAL FIBER
Two fiber optic connectors are present on the housing top with standard “Sea & Sea”
fitting. In this case you have to use the bushings for optical fiber placed on the top.
Pass the optical fiber cable of the flash in the specific space on the bushing.
With Optical Fiber you have to use pull up flash of the camera.
HOW TO CHANGE BATTERY
To remove the battery, use a small flathead screwdriver to lift up the battery.
Install a
CR2450 battery
into the battery compartment inside the front housing.
With SYNCRO cords (optional)
Strobes from
SEA&SEA, INON,
and
Nikonos
must be used in manual power modes
when connected via electrical sync cord.
An internal electric circuit controls the two syncro cords by means of 3 switches.
If the switch is positioned on
[ON]
it will be possible to
work with the flash in manual
or TTL
mode as indicated
in the figure below:
N.B.
this is also necessary in case of any troubles when using syncro cords with
the strobe in manual mode.
USING THE FLASH
ON
TTL
TTL
1
2
3
4
ON
1
2
3
4
