Isotra Heluz, Техническое руководство

Страница: 11 / 48

10 11
EXTERNAL ROLLER SHUTTERS
ENGINE CONTROL
9. Attach the cable from the engine to the connection box.
N.B. It is necessary to connect the cables according to the drawing of the engine supplier. The work with parts connected to the electricity
current must be carried out by trained experts. During the connection all the electric lines must be without electric current. Engines are
pre-adjusted, but in the place of the installation of the roller shutter they must be tested and the border settings must be adjusted.
CONTROL BY HANDLE:
10. Passing through the wall of the square joint bearing and fixation into the conical gearbox (in the box the square must be shortened ac-
cording to the fIxation).
11. Fixation of the joint bearing by the attached screws on the wall or the window frame.
12. Insert the handle (profiled tube) into the joint bearing and fi x it with the fixation clamp (plastic ring).
13. Fixation of the handle holder on the window frame or the wall.
14. Version of the box under the plaster.
· Before starting plaster work it is necessary to cover the joints between the box and the wall and the large area joint. (Additional fixation
and armouring prevents the origination of cracks from tension.)
The roller shutters must be assembled and
serviced by trained specialists
NUMBER OF FIXATIONS FOR ONE GUIDING BAR:
Height of the roller shutter up to
150 cm
> 2 fixation points in one guiding bar
Height of the roller shutter up to 250 cm > 3 fixation points in one guiding bar
This data is valid during assembly into the masonry with a sufficient load-bearing capacity. The same is also valid for data for the attached join-
ing material. The fixation material must be chosen according to the strength of the masonry and the static conditions of the particular case.
Guiding rails drilling
200
1/2
200
10
5,3
22
53
A) Z boku AXb
53
22
1/2
200
13,4
200
B) Z čela AX
10 5,3
D
C
B
A
2 1 5 6
6 5 2 3 4 1
D
C
A
B
B) face side AX
A) from the side AXb