Isotech TTI-7-R, Руководство оператора

Страница: 56 / 120

Operating the TTI-7-R
5.6.6 Starting the data log
Once you have set up the scanner, timer and data log memory you
can start to log data.
The bottom line of the Running Mode screen now displays:
Hold SLx x/yyyy Mem
Where SLx indicates the scanning list the scanner will use, Mem
indicates that data logging to memory is On, x is the number of
samples recorded and yyyy is the number of samples required.
1. To start logging data, press the 3/TRIG key. The bottom line of the
display now shows the Run message, and the sample number
starts to increase with each sample taken.
2. At any point, you can halt data logging by pressing 3/TRIG again, and
the
Hold message is shown. Logging will also switch to Hold
automatically once the TTI-7-R has logged the required number of
samples.
3. If the data log is complete i.e. the number of samples taken equals
the number of samples specified, logging stops and
Hold is
displayed. You can restart data logging only after the existing log has
been deleted or the number of samples required has been
increased. The screen displays:
Clear the current log?
Yes
No
4. Press [Yes] if you wish to delete the current log. Press [Yes] again,
to confirm that this is what you want to do.
5. Once the log memory has been cleared, press 3/TRIG to start the
data logger.
Page 5-22