Page 28 of 49
TTI-22 Iss.04– 11/15
Table 8.1: PC Commands
PC command
transfered data, examples
GET RSTAT
R1= 108.98370 Ohm
Mean= 108.98418 Ohm
S.Dev= 0.00026 Ohm
R2= 125.02094 Ohm
Mean= 125.02093 Ohm
S.Dev= 0.00003 Ohm
GET TSTAT
SENSOR1= No:000002
T1= +23.0535 C
Mean= 23.05659 C
S.Dev= 0.00183 C
SENSOR2= No:000001
T2= +64.6449 C
Mean= 64.64503 C
S.Dev= 0.00013 C
GET STATUS
TTI-22 atus
MAC: 000DD9010764
Mains supply
8.2
Transferring Measuring Data via Ethernet
For data transfer connect the Ethernet interface (LAN) of TTI-22 to a local network.
Caution:
Be sure to only enter configuration parameters that fit the network you use. If necessary, contact the
network administrator.
1.
Configure the Ethernet interface at TTI-22 in the menu 2 Edit Configuration > 5 Ethernet Config
as follows:
Fig. 8 - 3
Ethernet interface setting
The required IP address, Netmask (NM) and Gateway (GW) can be obtained from your network
administrator.
The MAC address (Media Access Control) is the unique address of the instrument and was already
entered ex factory.
2.
To request data, enter the IP address in your browser.
The temperature and resistance values will be displayed. Currently no further functions are
available.
