CubeOne LED stays solid red
1. Ensure you have proper internet access provided by your ISP from
the connected router.
2. Ensure the port on the CubeOne and router are working. The LEDs
VU[OL91QHJRZOV\SKILZVSPKNYLLUHUKÅHZOPUNHTILY
3. Ensure the CubeOne is receiving an IP address from the connected
router.
CubeOne is not found in app during setup.
1. Ensure the smartphone and CubeOne are connected to the same
local network.
2. Ensure the CubeOne is powered on.
,UZ\YL[OL*\PZZSV^S`ÅHZOPUN^OP[L¸IYLH[OPUN¹
After the registration process is complete, not all devices are
registered.
1. Remove battery from the un-registered devices. Wait at least 10
seconds and re-insert the batteries.
2. Observe the LED on each device during power-up. The red LED
ZOV\SKÅHZOVUJL0MUV[YLWSHJL[OLIH[[LY`
3. Launch the iSmartAlarm app and go to the
More
page.
4. Tap
Device Settings
.
5. Tap
Add
in the upper-right corner.
6. Select
Devices
.
7. After the devices have been found, tap
Add
to add them to the
system.
=PL^[OL
Device Settings
page and ensure the device is shown.
26
