ISLAND RETREAT NU6816, Установка и сборка

Страница: 2 / 11

1
INSTALLATION & ASSEMBLY OF THE SOLAR SHOWER
We recommend installation of the Outdoor Solar Shower on a solid surface to ensure stability and safety.
When using tools, care must be taken not to damage the chrome plating and/or the plastic mounting base, we
suggest using a cloth between the wrench and shower parts to avoid damage.
MOUNTING THE SOLAR SHOWER: CONCRETE/MASONRY INSTALLATION
1. Choose a location for the shower that will receive the most direct sunlight.
2. Use the steel base plate on the lower tube as a template to mark the location of the mounting holes to be drilled into the
concrete/masonry for the anchoring bolts – see
Figure 3 .
3. Remove shower section. Drill 10-mm (0.5-in) diameter holes, 45-mm (1.75-in) deep into the concrete/masonry surface,
using the marks just created.
4. Insert expansion nuts into drilled holes. Place the bolt inside the expansion nut and TAP with a hammer to slightly
expand the nut.
5. Remove the bolt and place the base plate/lower tube over the holes and secure to surface with bolts and washers
provided - see
Figure 3 .
6. Proceed with the assembly process as outlined in section ASSEMBLING THE SOLAR SHOWER .
MOUNTING THE SOLAR SHOWER: WOOD DECK INSTALLATION
1. Follow instructions #1 & #2 for Concrete/Masonry installation to mark where you want the shower installed.
2. Select appropriately sized anchoring wood screws and washers (not included) to secure the shower to the wood decking.
3. Drill starter pilot holes at the marked locations.
4. Secure the base plate to the wood deck with the large anchoring wood screws and washers.
5. Proceed with assembly as outlined in section ASSEMBLYING THE SOLAR SHOWER.
MOUNTING THE SOLAR SHOWER: USING THE INCLUDED PLASTIC BASE
Contents
Pc Description Qty
12 Bolt +
Nut
4
1. Turnover and layout the 4 pieces of the shower base so that the tabs interlock.
2. Press them together to make one large square base.
3. Insert the nuts into the slots on the underside of the base.
4. Set the bottom half of the shower tube on the top of the base plate.
5. Use a Philips screwdriver to align the nuts with the holes in the metal plate of the shower.
6. Insert the bolts with washers into the base plate. Thread and partially tighten each bolt.
7. Once all 4 bolts are partially tightened - proceed to firmly tighten all bolts.
Pc Description Qty
1 Base 4