ISLAND RETREAT NU6816, Установка и сборка

Страница: 4 / 11

3
INITIAL SET UP OF THE SOLAR SHOWER
1. Turn and lift the shower handle to FULL ON - HOT position.
2. To fill the shower with water, turn the water valve for the garden hose on. Shower will take about 2 minutes to fill.
3. NOTE: Filling tube with valve in hot position ensures no air pockets are trapped in shower. This procedure is used for initial
set up only or when re-opening the shower after winterizing.
4. When water flows from the shower head, turn the shower handle off. Turning the shower off allows the water to begin
heating.
5. The shower is ready to absorb sunlight and heat the water in the black solar reservoir tube.
NOTE: The time for heating the water depends on the outside temperature and the strength of the sunlight. You can expect a
water temperature increase of about 10 degrees over the air temperature, but that can vary depending on the amount of
sunlight, time of day, and how windy it is.
CAUTION: Do not shower during lightning storms.
CAUTION: ADJUST WATER TEMPERATURE GRADUALLY FROM COOL TO HOT TO AVOID INJURY
1. Lift the handle to the ON position and you are ready to enjoy your solar heated shower!
NOTE: The water supply must be turned on for shower to run - Warm water flows at approx. 2.6 GPM (10.3 I/min).
Cold water flows at approx. 2.9 GPM (10.9 I/min).
2. Turn off the water supply to the shower when done.
WARNING: DUE TO THE SOLAR RADIATION THE WATER IN THE SOLAR RESERVOIR CAN GET HOT.
WE RECOMMEND OPENING THE HANDLE IN THE MIDDLE POSITION BETWEEN HOT AND COLD, THEN
SETTING IT TO DESIRED TEMPERATURE.
IF SHOWER HAS NOT BEEN USED FOR MORE THAN THREE DAYS, WE RECOMMEND
RUNNING THE SOLAR SHOWER FOR 2 MINUTES TO REMOVE STAGNANT WATER, STAGNANT WARM
WATER CAN DEVELOP HAZARDOUS BACTERIA.
OFF SEASON DISASSEMBLY & STORAGE:
FOR WINTERIZING THE SHOWER IN COLD WEATHER CLIMATES, THE WATER MUST BE COMPLETELY
REMOVED FROM THE SOLAR SHOWER. THE SOLAR SHOWER HAS TO BE REMOVED FROM THE
MOUNTING LOCATION AND STORED IN A DRY PLACE. FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY CAUSE FROST DAMAGE. FROST DAMAGE WILL NOT BE COVERED BY THE WARRANTY.
1. Turn off and disconnect the garden hose.
2. Open the handle and allow shower to drain (approximately 2 minutes).
3. Unbolt the shower PVC tube and pour any remaining water out of unit.
4. Wipe down and store your shower parts for next season.
CAUTION: DO NOT USE SALT OR ANTI-FREEZE IN THE WATER TO PREVENT FREEZING. THIS WILL VOID
THE PRODUCT WARRANTY.
Keep this manual for future reference and pass it on to any new owners of the shower.